Nokia E5-00 - Telephone settings

Select Menu > Ctrl. panel > Settings and Phone.

Select from the following:

Call - Define general call settings.

Call divert - Define your call divert settings. See Call divert.

Call barring - Define your call barring settings. See Call barring.

Network - Adjust the network settings.

Call settings

Call settings

Select Menu > Ctrl. panel > Settings and Phone > Call.

Select from the following:

Send my caller ID - Display your phone number to the person you are calling.

Call waiting - Set the device to notify you of incoming calls while you are in a call (network service).

Reject call with message - Send a text message when you reject a call, informing the caller why you could not answer the call.

Message text - Write the standard text message that is sent when you reject a call.

Own video in recvd. call - Allow or deny video sending during a video call from your device.

Image in video call - If video is not sent during a video call, select the image to be displayed instead.

Automatic redial - Set your device to make a maximum of 10 attempts to connect the call after an unsuccessful call attempt. To stop automatic redialling, press the end key.

Show call duration - Display the length of a call during a call.

Summary after call - Display the length of a call after a call.

Speed dialling - Activate speed dialling.

Anykey answer - Activate anykey answer.

Contact search - Activate contact search in the home screen.

Network settings

Network settings

Select Menu > Ctrl. panel > Settings and Phone > Network.

To select the network mode, select Network mode and Dual mode, UMTS, or GSM. In dual mode, the device switches automatically between networks.

Tip: Selecting UMTS enables faster data transfer, but may increase the demand on battery power and reduce the battery life. In regions close to both GSM and UMTS networks, selecting Dual mode may cause constant jumping between the two networks, which also increases the demand on battery power.

To select the operator, select Operator selection and Manual to select from available networks, or Automatic to set the device to select the network automatically.

To set the device to indicate when it is used in a microcellular network (MCN), select Cell info display > On.